Selected Store
Stock 3 pieces
Set the delivery location to see products according to your choice.
© 20[0-9]{2} Skroutz SA All Rights and Lefts reserved. FAQ | Terms of use | Privacy Policy | Cookie Policy
Selected Store
Stock 3 pieces
Misc Cooling Parts
Prices are calculated for:Luxembourg, Other Payment Options
Provides effective cooling, allowing maximum read/write speed for single and double-sided M.2 2280 units.
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.
It dropped a Samsung 970 Evo Plus 2TB M2 around 6 to 8 degrees sturdy and high-quality construction. The screw of the Gigabyte motherboard I had screwed it without any problem. It would be good to drop the temperature even more
Quality construction with integrated copper heat pipe, reduces temperatures by an average of 6 - 8 degrees. Attention to installation is required due to increased thickness, needing longer screws compared to those included with most motherboards, which unfortunately are not included.
In an SN850X, 10 with 12 degrees below. From 58 to 48, 46 that is.
Of course, when the processor and pciex16 start to warm up, the troubles begin... 5 degrees below on average.
Is it worth it for 10 to 12 euros? Yes. For more? No, hence the 4 stars
Previously, I had evaluated the simple MC1 PRO, definitely better and it lowers the temperature four degrees lower than the previous one.
It does what it's supposed to, small issue with the thermal pads sticking so much that the screws for support are not really needed, I'm afraid if I need to remove it, it won't come off.
Very good construction quality. It is made of aluminum and has two heat pipes. It covers the SSD from both sides, making it suitable for SSDs that have chips on both sides. The two parts are connected with four screws. The package also includes a magnetic screwdriver for this job - pay attention to the detail. The thermal pad is good, without sticking excessively. It requires careful alignment with the SSD so as not to obstruct the screw that holds it down. The instructions are in English and very detailed. I can't say much about its performance at the moment. It keeps the temperature of the SSD (a Corsair Force MP510 480 GB) stable at 34 degrees, which was also the case before I installed it. However, it is winter and any difference will be noticeable in the summer. Like any passive cooler, it relies on good ventilation of the case. For now, I give it 5 stars due to its good construction, and I will update the review downwards if necessary in the summer.
Very good build quality, easy installation, although it requires a little attention to fit correctly. I did not measure the temperature difference before and after, but I read reviews from other users, and it is given due to the construction, that it has an effect.
Very good cooler, it significantly reduced the temperatures on the 960 evo (about 5 degrees). The decrease was mainly measured in the month of August, where I noticed a difference compared to the previous cooler, which I had for the past 2 years, and went from 51 degrees under full load to a maximum temperature of 46 degrees. Its quality is at a very high level and it comes with the appropriate screwdriver
It does what it promises, if you don't make extreme uses again you won't see a big difference, you also have a screwdriver as a gift for the very small screws.
Very good product, easy installation. Used on a new NVMe (purchased simultaneously), so I don't have temperature comparisons before and after
It lowers the temperature and keeps it stable on both SSD sensors in a case with good air flow.
It is a pretty good cooler, but on the PS5 that I installed it, I couldn't close the metal door due to its height and I left it open. BE CAREFUL, THEREFORE, IF YOU WANT IT FOR THE PS5, THIS PROBLEM EXISTS.
It does what it says! Very good cooling... but, I had a hard time removing it from the hard drive, the thermal pad that it had on top and bottom had stuck to it and had become like chewing gum, anyway with a lot of effort and a spatula I managed to remove it but it requires caution as it can easily cause damage. Also, in order to reinstall it, you will need to find new thermal pads of the same thickness and with good thermal conductivity!!!!!!!!!
Very good cooler, significantly reduced temperatures on the 970 evo. The quality is at a very high level
Amazing passive cooler. It is not only aluminum with fins, but it also has a double copper rod inside it, as well as a thermal conductive pad between them and the disk.
Verified purchase
For SSDs that do not have a heatsink, it is a cheap and good solution to lower the temperature significantly.
Verified purchase
a bit useless but cool
Verified purchase
The company is top
Verified purchase
It lowers the temperature by 15 degrees.
poor heat dissipation
The ssd 970 evo plus se gaming does not exceed 52 degrees
Easy to install, but nothing special... I have the same temperatures as before
Verified purchase
The controller of the 970 EVO 1TB reached 62 degrees, and with the heatsink now it is a maximum of 55.
Verified purchase
It does the job for which you get it
Verified purchase
Flawless, very high-quality construction, installation was without any issues.
Verified purchase
Be Quiet Cooling top-notch flawless cooler
Verified purchase
About 5 degrees lower, it's fine