Skroutz.eu

The power supply is exclusively provided through PoE (it does not have a separate power connector).

The PoE connector is located on the back side of the device, so in order to mount it on a wall, you must use an embedded box inside the wall with two screw holes that are horizontally spaced 60mm apart. The EAP615-Wall base, which is included, will be screwed onto this box.

The device is small and attractive, and if it is mounted on a wall using the above method, it is very discreet. The only button the device has is to turn on/off the single LED that is present (not the device itself, only the LED).

Its range is almost the same as the previous one I had, perhaps slightly smaller.

The entire device, except maybe the section below the LED, gets quite warm. It doesn't burn, we can keep our hand on it, but it feels like it has a high fever and something more.

Other than that, everything is good.

Finally, normal colors at night.
The previous bulb that existed was so intensely yellow that it was the reason that led to the search for a better bulb, resulting in this specific CrystalVision.
Perhaps the intensity of the lighting is about 5% lower than the previous one, but it doesn't bother. The shade is the best one can hope for.

The two bulbs it has produce enough light, so using it indoors is rather annoying.
Otherwise, it works just fine.