Skroutz.eu

Analyzing the 4 main criteria for purchasing an induction hob: 1) maximum power 2) minimum power 3) power levels 4) timer, we understand why the Esperanza EKH011 is a best seller and the best value for money hob with a price below 20€.

1) The maximum power of the hob is 1470W, like all hobs that state 2000W. More than enough power for cooking anything. In essence, the cookware with the food can heat up quickly, usually within 1 to 5 minutes, and then we can choose to cook slowly for as long as we want.

2) The minimum power is 200W. Not catastrophic if you don't cook very small quantities.

3) The power levels are sufficient for this hob category (up to 50€).

4) The timer helps with easy and perfectly cooked meals.

Pros: The hob is easy to handle even by a child, without needing to refer to the instructions.

Cons: The hob is not good for upgrading to ultra smart, as it would require at least 3 modules, preferably 4, and ideally 5 modules. Apart from the cost, programming is time-consuming and complicated, while the modules with the power supplies barely fit.

Comparison with other hobs:
From 2018 to 2020, Xiaomi had the best smart induction hob as it had 100 cooking levels! However, it fell short as its smart application had only basic functions that did not meet basic needs, and it had a problem with the temperature sensor, which required replacement every 12 months at a cost of 20€ (excluding labor), when the entire device cost around 55€. That is why Xiaomi has disappeared from this sector. Conclusion: this hob costs less than a Xiaomi temperature sensor and has a 2-year warranty. Also, at the moment, to get a better machine with a few more options, you have to spend over 50 euros, while if the available smart devices do not meet your needs, it is better to build one yourself by buying an Electra EH-0520IC and upgrading it to ultra smart.

Purchased for 19€.

Data, specs + compare:
Standby power 0.4W
Power check 1.4W (electricity button)
Fan power up 6.3W
Off timer preset 10min
Off timer set from 1 to 180min (3h)
Off timer increment 1min
Start timer preset 30min
Start timer set from 1 to 1440min (24h)
Start timer increment -1min, +30min

FUNCTIONS:
F1 Boil 200W = 1010W on/off for target
F1 Boil 500W = 1010W on/off for target
F1 Boil 800W = 1010W on/off for target
F1 Boil 1000W = 1010W steady
preset: F1 Boil 1600W = 1210W steady
F1 Boil 1800W = 1310W steady
F1 Boil 2000W = 1470W steady
Only off timer is available for boil function.

F2 Fry 80c = 1010W until temp reached
F2 Fry 100c = 1010W until temp reached
F2 Fry 130c = 1010W until temp reached
F2 Fry 160c = 1010W until temp reached
F2 Fry 180c = 1100W until temp reached
F2 Fry 210c = 1200W until temp reached
preset: F2 Fry 240c = 1310W until temp reached
F2 Fry 270c = 1465W until temp reached
Only off timer is available for fry function.

F3 Heat-up 500W = 1010W on/off for target
Only start timer is available for heat up function.

F4 stew 1300W = 1475W steady
Only start timer is available for stew function.

F5 water 2000W = 1470W steady
Only start timer is available for water function.

Fan wings diameter: 11 cm
Fan slot maximum capacity: 12 cm

Comparison of the fan with EH-0520IC:
Size: 50% smaller
Noise: 50% less

Power comparison with EH-0520IC:
Same: 1470W

Induction coil dimensions:
External dimension (usable): 15 cm
Internal dimension (dead): 4 cm

I mistakenly believed that I should keep the old mixer that I had received for free with a Nescafe package, until it broke down, as I had the opinion (like many others) that it is the best on the market. The mixer was purchased out of necessity, and with a lot of reservation, as I believed that because it is one finger longer, it would be extremely unstable, and that its metal tip would be inferior to the plastic one. After the first use, I found out that:
1) Its stability is such that if I didn't hear its operation, I might not realize that it is working.
2) It operates at the same speed both inside and outside the frappe, no matter how thick it is. This did not happen with previous mixers I had, even on the day they were purchased.
3) My old mixer took two minutes to froth the foam I desired, even when it was new... This one only took 6 seconds!
Thoughts:
Although I frequently handle high-speed machines, I am shocked by this machine... I wonder if I could adapt a router bit for engraving (convert it into a multitool), and what else I could transform it into... we will see as it is only the first day of use. Purchase price 10.90€

Under very specific conditions, this is the best vacuum cleaner that someone can buy, even compared to models that cost hundreds of euros.

The criteria and ratings related to the above are as follows:
1) Ease of use: 10/10
2) Quiet operation: 9/10
3) Dust retention: 10/10
4) Easy cleaning: 10/10
5) Build quality: 9/10
6) Durability: 10/10
7) Low purchase cost: 10/10
8) Low operating cost: 10/10
9) Transparency of the bin: 10/10
10) Universal type accessories: 10/10

With the exception of this specific vacuum cleaner, there is no other vacuum cleaner on our planet with an average rating above 8.

The three conditions for the above to be true are as follows:
1) The vacuum cleaner must operate with universal type accessories **1 and not with its own.
Specifically:
A) Nozzle with a slot for 32mm hoses.
B) 32mm diameter hose.
C) "G" handle compatible with the rest.
D) Spiral hose.

**1 We can obtain accessories of this type new from any store, and any manufacturer - brand, at a very low price (25€ for all) or use the accessories of an old vacuum cleaner as they have a lifespan of 10 to 100 years.

2) We need to improvise regarding the adapter that connects the spiral hose to the vacuum cleaner, for which a 10cm long, 32mm diameter pipe is sufficient, preferably made of PVC, which we will wrap with duct tape on both ends to fit tightly and with sealing.

3) The filter is not easily found as a spare part, so:
A) We never wash it.
B) We always use an extra filter **2.
C) We clean it by lightly tapping the black "lid" with the handle of a wooden or plastic brush.
D) We never tap the filter on the white surface or the large side that fits into the bin! !
E) We clean the filter peripherally with a brush on the black surface, not on the white surface!
F) For cleaning all other parts, we use a brush and if desired, we change and wash the extra filter **2.
G) We never let the bin fill up halfway. We empty the bin and clean the filters as soon as it is filled to 1/4 or 1/3. This is sufficient for a house of 50 to 100 square meters, depending on its cleanliness, thus protecting the filter from any high pressures due to the collected dirt.

**2 As an extra filter, it is suggested to buy a 100% synthetic women's sock, costing around 1€, which will "produce" at least 4 filters with a lifespan of about one year each.

The above technique extends the lifespan of the vacuum cleaner from 2 years to 10 years (read the end). With the same technique, the filter is cleaned up to 10 times easier, faster, and more effectively.

After a technical analysis, we can say that the motor is a jewel of design, performance, and technology that is hard to find better. The rest of the vacuum cleaner's design could be better, making it even quieter up to three times, but slightly increasing the volume, weight, and certainly the cost. However, do not be deceived by the above comment, the vacuum cleaner is extremely quiet.

End: just like everything around us is designed and manufactured with weaknesses in order to be destroyed so that we buy new ones, this vacuum cleaner also has its "weak point", which is its filter. If used as is without the aforementioned tactic, it renders the vacuum useless after approximately 100 to 150 hours of operation, which translates to a period of 2 to 2.5 years, meaning the end of the warranty. The calculation was based on using it for 10 minutes per day or 60 hours per year.

Numbering of the three photos:
1) The complete vacuum cleaner.
2) Components with a total cost of 25€.
3) Extra filter that needs to be applied.
4) Origin of the extra filter.
5) The extra filter was properly placed in the bin.
6) Adapter between the hose and the bin.
7) This side requires 1 extra wrapping.
8) The adapter.
Purchase price: 24.90€
Update 19/3/23: Two years ago, the filter was very expensive and only available from German websites. At the moment, the filter is available everywhere for a price of 3.50€. This adds value to the vacuum cleaner, but it does not change the tactic in terms of usage. I will immediately purchase the filter and post an evaluation on its page as soon as possible, covering its origin-authenticity, application in the bin, pollutant retention capacity, construction quality, compared to the filter that the vacuum originally had. I found the filter on Skroutz by using the keyword "deerma dx115".

If you want dehumidification in the summer or in a heated space, then use your air conditioner. This dehumidifier is extremely efficient only if the room temperature is below 22°C and the humidity is above 60%. It can also work for months with minimal consumption as long as it is connected to a drainage system. If you refer to the official product photos, you will see that it has 6 buttons. If the leftmost button is the 1st, then the far right button is the 6th, and it is the yellow power on/off button. This is the only button you will need. Above this button, there are indicator lights that turn on if the tank is full or if the filter needs cleaning. Buttons 1 and 2 may never be used as the 1st one activates the ionizer while the 2nd one selects the operating time for 2, 4, or 8 hours. The 3rd button controls the blind's movement. If we haven't selected anything, the blind always points upwards, which is ideal. It is advisable not to select the 4th button as in both options, the fan operates at "high" speed. The drawbacks of the fan on "high" are highlighted by the 5th button (intensity) which, if you select "high": firstly, the fan operates with deafening noise. Secondly, the consumption increases significantly. Thirdly, the dehumidification performance in relation to the air passing through it drops dramatically. Fourthly, prolonged use on "high" quickly dirties the filters. Therefore, the "auto" option is also rejected as it can activate the "high" speed, with the only logical choice being the "low" speed with extremely quiet operation. If we only select "low," simply turn the dehumidifier on and off from the power button as it retains the last setting. When turning off the dehumidifier, the fan will continue to operate for a few more minutes for safety reasons, which is normal. Upgrading to smart does not make sense as it can remain on for long periods due to its low consumption. An exception to the above is placing the dehumidifier in every room with permanent installation. It is considered normal that with the machine's operating mode, it takes at least two hours for a noticeable drop in humidity. For maximum performance, do not place it near sources of heat. An economical and excellent machine ideal for the elderly.
Purchase price: €150
Update 2/5/23: Regarding the average consumption "A.C." (Average Consumption): Consumption varies automatically from 30 to 300 watts depending on the ambient temperature and in relation to the temperature of the zeolite (the zeolite must always be warmer). Depending on the region (e.g. Crete-Evros) and the season, consumption may vary, making the A.C. inaccurate. Having clarified the above, the A.C. that I usually see is 2.3 kilowatt-hours in a 24-hour period of use. Therefore, A.C. is around 100 watts.