Do not install the controller in wells, below ground level, or inside buildings. Do not use the programmer with chemicals or liquids other than water. Do not use the programmer with operating pressures below 0.5 bar (7.3 psi) or above 10 bar (145 psi).
Secure the programmer using the retaining ring.
Connect the hose to the irrigation line.
Press the two side buttons to open the programmer.
Insert a brand new 9V alkaline battery.
Important: remember to turn on the water tap.
The features of all programs are summarized in a list displayed on the protective cover.
At the time you want the watering to start, turn the dial to the desired program.
The selected program starts after 10 seconds.
You can change the irrigation program at any time by turning the dial to the OFF position.
Then, when you want the watering to start, move it to the new desired program.
Turning the knob to the OFF position cancels the execution of the program in use.
Wash the filter at the end of each season and check it periodically.
Turn off the tap and loosen the tightening ring nut by turning it counterclockwise.
Unscrew the 3/4” inlet nut from the tap by turning it clockwise.
Remove the filter and rinse with running water. After washing, reassemble everything.
At the end of the season, before the arrival of winter frosts, disconnect the programmer from the tap.
Remove the battery.
Store it in a closed and not humid environment where the temperature does not drop below 3°C.