230V AC 1P RS-407B Radio Control Relay

Electronic radio relays are used for remote control of gates, shutters, lighting, alarm system arming, etc. The remote control system consists of a transmitter (remote control) and a receiver (relay). It is possible to operate multiple transmitters with one receiver and a single transmitter with multiple receivers.

Action: The pulse generated by pressing a button on the remote control sends a coded signal to the receiver. The remote control has protection against transmission interruption after the button is released. Thanks to this, even the briefest activation of the function results in the transmission of a complete data frame. The data transmission from the remote control is indicated by the red LED on the remote control flashing. When the signal is recognized, the receiver will change the contact position to the opposite position.

The RS-407B receiver works with exclusive devices manufactured by F&F: RS-P transmitters (remote control) and RS-N (flush-mounted transmitter). The receiver's memory can store up to 32 transmitters. The operating range of the system is up to 100 m, which depends on various factors such as weather conditions, terrain characteristics, height of the receiver and transmitter, and various obstacles.

WARNING! Before the final assembly of the receiver, perform tests. The receiver is equipped with a PROG button that allows associating a given remote control/button with the receiver and deleting its memory.

Programming: Press and hold the PROG button for >5 seconds to enter programming mode. After entering learning mode, the receiver waits for incoming transmissions from the remote control. If the button on a given remote control has not been previously programmed, the recognition data will be stored. Multiple remote controls can be matched during an open programming session of the receiver.

Receiver signaling:

• LED red flashes randomly: data reception mode
• flashes quickly: memory deletion
• long flash: memorization of the function (remote control)
• short flash: the function (remote control) is already defined
• 3 flashes: memory full
• prolonged flash: memory formatting after activation
• red short memory test flash after activation
• LED green: flashes every 1 second: learning mode
• long flash: output activation

Technical specifications: power supply 230V AC.