Reviews by our members

• 4

  Nikos44317

  2025-02-12

  Verified purchase

  It is compatible with the Creality CR6-SE where I installed it (photo 1) when the original plastic cracked.
  The positives:
  Because it has a dual gear, the extrusion is smoother and the filament gets less deep grooves. Also, the pressure is greater and I haven't had any jams yet.
  Additionally, the path of the filament is visible and there is no need for any unscrewing to see if the filament passage is smooth.
  The negatives:
  To release the filament, continuous pressure on the lever is required. The old plastic remained "open" steadily without effort.
  The filament passage hole is about 6 millimeters higher. So it is not aligned with the filament continuity sensor. It needs to be raised by 6 millimeters. It's not difficult; it just requires two slightly longer screws and 6-millimeter washers/spacers (photo 2).
  WARNING! Because the diameter of the gears is smaller than that of the old single gear, it is necessary to update the Steps per unit parameter of the controller. There are instructions on the web on how to do this (e.g., search calibrate e-steps).
  After the above, I am very satisfied.

  Translated from Greek · Show original

  • 
  • 
  Did you find this review helpful?YesNo

  Report