The kit does not include the bracket (like the rest of the brackets) for the sensor, even though they are depicted as part of the kit in the product photo in the store.

Very good and does exactly what it says. You will never need (almost) bed leveling again, BUT (and it's a big but), it may also be the fault of the ender 3, I don't know, I struggled for almost a week to find the right firmware. The accessory is not plug and play, you have to experiment a lot with the z axis and cross your fingers that you will find the right firmware since Creality's website in this aspect is awful. It should also be noted that from a certain point onwards, I simply ignored the instructions in the box (just like I did with the assembly of the printer) and simply watched a lot of tutorial videos where I managed to figure things out little by little. 5 out of 5 because the issue is due to Creality and not their CR touch.

There is no room for criticism, it is an accessory that does exactly what it says. Before purchasing, make sure you have a 32-bit board because otherwise you cannot install it.

One of the best accessories you can add to your printer is the Creality3D CR Touch Auto Leveling Sensor Kit. This kit does exactly what it says and greatly facilitates the Bed Leveling process. You don't need to use rulers or paper to find the correct distance between the nozzle and the bed. Simply install the sensor, connect it to the board, and perform the auto leveling function from the screen. The kit includes everything you need to install the sensor, including screws, brackets, and cables. It's worth the extra effort to route the cable through the cable protection mesh along with all the other cables, even though it's not mentioned in the instructions, to have a neater and cleaner appearance. In summary, the CR Touch is a must-have for anyone looking to improve the quality of their prints.