- Immerse the OzDenta in boiling water for about 15-20 seconds or until you see the edges curl.
- Then remove it from the heat source and let it cool for a few seconds. DO NOT place the mouth guard in the water while boiling.
- Carefully place the mouth guard on the upper jaw. With your lips compressed, suck out all the air to achieve a precise fit on your teeth.
- Use your tongue to apply pressure to the inner walls and simultaneously use your fingers to press the outer walls.
- Do not chew the mouth guard during the fitting process to ensure it is as precise as possible.
- This process will take 1 minute. Once you have finished the process, place the OzDenta in cold water for 2 minutes and the mouth guard is ready for use. If the OzDenta mouth guard is not precise, repeat the steps.
- After each use, clean it thoroughly. Use only one mouth guard at a time and replace it when it wears out.
- This process is done ONLY the first time.
-7%for 2+ items
Selected Store
Stock 20+ pieces