- We tape the area around the headlights with masking tape
- We sand the headlights with water sandpapers and water starting from P320 or P600 depending on the condition of the headlights. We proceed with sandpaper P800, P1000, P1500, P2000 & P3000. The sanding should be meticulous and uniform over the entire surface of the headlight.
- We place the chemical inside the lamp above the middle of the container because otherwise, there is a risk of burning the heating element.
- We close the heating container with one of the two lids and wait about 4-5 minutes for the liquid to boil.
- When we see that the steam has started to come out of the spout, we approach the headlight at a distance of about 5cm starting from the bottom to the top in a horizontal left-right motion and move up with slow movements without leaving gaps.
- In less than a minute we are done and after 10 minutes our headlight is ready.
39,00 €
Selected Store
Stock 5+ pieces