The P-30A-050 is made from high-quality PC and ABS materials, which translates to high shock absorption. This makes the drone less prone to damage, even during emergency landings.
Selected Store
Stock 2 pieces
Set the delivery location to see products according to your choice.
© 20[0-9]{2} Skroutz SA All Rights and Lefts reserved. FAQ | Terms of use | Privacy Policy | Cookie Policy
Selected Store
Stock 2 pieces
Take-off / Landing Gear for Drones
Take-off / Landing Gear for Drones
Take-off / Landing Gear for Drones
Take-off / Landing Gear for Drones
Take-off / Landing Gear for Drones
Take-off / Landing Gear for Drones
Take-off / Landing Gear for Drones
Prices are calculated for:Luxembourg, Other Payment Options
Reinforcing the vehicle increases the stability and safety of the drone during take-off and landing. It raises it by 25 mm and thanks to its lightweight design (17 g), it does not affect the flight of the DJI Mini 3 Pro. It does not need to be disassembled for storage and the silicone pads provide shock absorption.
The P-30A-050 is made from high-quality PC and ABS materials, which translates to high shock absorption. This makes the drone less prone to damage, even during emergency landings.
The installation of the lift will not cause you any problems. Thanks to its well-thought-out design, you will be able to install or disassemble it in no time without worrying about damaging or scratching your drone. Also, you do not need to remove the P-30A-050 to assemble the DJI Mini 3 Pro.
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.
Very good quality. Well thought out to fit in a specific place and not come off easily. They do their job. WARNING, let's not forget that even though they are just a few grams, they raise the weight of the drone above 249 grams. I mention this for legal flight reasons.
They were purchased from a store that is not on the platform. As for the construction, it is sturdy and convenient for storage, meaning you don't need to remove them to put them in your bag.
The first drawback is that you have to open the front arms first and then the back ones.
The second and significant drawback is that the drone's inclination changes compared to the ground, making it lean more horizontally. I roughly measured that without the landing gear, it has an upward tilt of 15-16 degrees, while with the landing gear, it is 9-10 degrees. So when it tries to take off, it moves forward and the front propellers hit the ground, preventing it from taking off. You have to press the throttle very abruptly upwards.
In the Mini 2, it was much better designed and I didn't have such problems.