PGP FIBRATED FILLER is a ready-to-use, acrylic filler reinforced with rock wool, for interior and exterior use. It is suitable for filling cracks and holes in walls, ceilings, floors, and doors. Thanks to its special composition, it does not crack and can absorb movements and vibrations without breaking. It can be applied to all common building surfaces.

• Ready to use
• Reinforced with rock wool
• Easy to work with, fills and levels excellently
• Dries quickly and sands easily with sandpaper
• Shows minimal shrinkage without cracking
• Offers excellent stability once dried
• Creates a perfect non-absorbent surface ready to be sanded and painted
• Interior and exterior use
• Speed - cleanliness

• Filling imperfections on walls and ceilings of building surfaces before painting.
• Suitable for plaster, smooth cementitious surfaces, aerated concrete, gypsum board, cement board, etc.

• Surfaces must be dry and free from dust, oils, and loose residues.
• Large cracks or seams are recommended to be primed with a water-based primer.
• Applied with a spatula.
• Press the material onto the surface in a thickness not greater than 5mm.
• For larger fillings from 0.5 – 2cm use mesh or plastic netting for reinforcement.
• Allow each layer to dry before the next application (approximately 1 hour).
• Fill the opening leaving excess material to shape the final surface more easily with a wet spatula.
• Once the surface is dry, it can be sanded with sandpaper.
• The final surface can be primed and painted.
• Close the lid immediately after application to maintain the product's moisture.
• A suitability test of the product is recommended.

• Not suitable for plastic and metallic surfaces.
• Should not be applied outdoors when rain is expected (at least 5 hours before rain).
• Should not be applied at temperatures (ambient and surface) below 5°C.
• Not suitable for application in permanently humid areas.

• Yield: depending on application
• Thinning: none
• Application: with spatula
• Initial drying: 30 minutes 20°C
• Final drying: 1 - 2 hours 20°C
• Application temperature: 10°C - 35°C
• Cleaning: with water