Selected Store
Stock 5+ pieces
Set the delivery location to see products according to your choice.
Selected Store
Stock 5+ pieces
2 years warranty
Solar Water Heater Accessories
Solar Water Heater Accessories
Solar Water Heater Accessories
Solar Water Heater Accessories
Solar Water Heater Accessories
Prices are calculated for:Luxembourg, Other Payment Options
The special Doro-Cup covers protect your solar heater from the sun in your absence and significantly reduce the internal temperature, thus extending the lifespan of your solar heater.
Protect your solar water heaters from the sun's rays when you are away from home for a long period, such as at your vacation home, etc. The water accumulated inside the boiler can reach temperatures up to 80°C and, as it is not used, it literally boils, resulting in damage to your solar heater and your household's water supply network.
The special Doro-Cup covers protect your solar heater from the sun and significantly reduce the internal temperature. They also protect from frost caused by extreme weather conditions (hail, snow).
The cover is made of aluminum and PEX foam class E insulation.
Technical specifications:
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.
Good only for the first year. Afterwards, it peels off and the retention straps and loops of the cover are cut like tissue paper. Good only for the first year.
The worst thing you can tear for fun, wasted money.
1 summer and the straps broke... Next time, let's go for a canvas tent.
POSITIVES
- Complete solar radiation impermeability
NEGATIVES
- The covering material is some kind of compressed foam, on the outer reflective side of which has been plasticized. Well, this plasticization breaks if it is pressed or folded (which is inevitable during the storage of the cover)!
- Because the covering material is a bit hard, it tears at the point where the gas has been sewn around.
- The corner loops intended to embrace the corners of the mirror are small and cannot embrace the thickness of the panel, making them useless.
- The loops located on the sides of the cover are placed on top of the seam. CAUTION!!! Do not pass the fastening straps as the manufacturer specifies, i.e. through the loops and behind the back of the panel, because the cover will tear at the point where it has the loop with the seam with the slightest wind pressure or tightening!!! Pass the straps through the loops so that the straps pass over the cover and then behind the back of the mirror (i.e. tie the cover around the mirror).
- Very expensive for the quality of the product. Next time, I will prefer a cover made of tent fabric or insulation board dow.
Good only for the first year. Afterwards, it peels, breaks, and the holding straps get cut.
Verified purchase