Set the delivery location to see products according to your choice.
Selected Store
Stock 5 pieces
Prices are calculated for:Luxembourg, Other Payment Options
White primer for plasterboard. It simulates the absorbency between the paper of the plasterboard, the joint compound, and the rest of the surfaces to be painted.
The Plasterboard Primer is a water-based acrylic primer for interior use, with excellent filling capacity for plasterboard surfaces as well as surfaces made of plaster, concrete, spackled, etc. Due to the high filling capacity of the product, it simulates the absorbency between the paper of the plasterboard, the joint compound, and the rest of the surfaces to be painted. Additionally, any irregularities in the paper of the plasterboard are fully covered. The final painting of surfaces primed with Plasterboard Primer, with any decorative water-based color, results in a flawless and uniform finish from the first coat. The product is practically odorless during application.
- High filling capacity
- Fully covers irregularities in the plasterboard
Technical Specifications
- Surface drying time: 30-60min
- Dilution ratio with water: 10-15%
- Coverage: 12-14m2/lt
- Application with brush
- Application with roller
- Application with spray gun
Surfaces should be clean, dry, and smooth, without dust, oils, or any loose materials.
For filling holes and smoothing any cracks, Acrylic Building Filler or Visto is used.
The product should be well stirred before use. It can be applied in one or two coats with a roller, brush diluted with 5-10% water, or an airless spray gun diluted with 10-15% water. It should not be applied at temperatures below 5°C, above 35°C, and/or at a relative humidity above 80%.
The product is touch dry in 30-60 minutes and can be recoated after 6-8 hours with Vitex plastic or acrylic paints. These times may vary depending on the weather conditions (relative humidity and temperature).
The tools should be cleaned immediately after use with water and, if necessary, with soap or detergent.
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.
I don't know if I came across a problematic batch, but it was not of good quality at all. It was tighter than cement and it took me 2 hours to thin it out enough to work with a brush or roller. The water I had to add was not 10-15%, but 100%, even mixing it with an electric mixer, but there were still hard pieces left inside. I had to strain it through a sieve to get a homogeneous paste. Even so, it did not spread well at all and started peeling off within a week.
Deals
Technology
Home & Garden
Fashion
Sports & Outdoors
Health - Beauty
Baby & Kid
Auto - Moto
Business - B2B
Books