For places where water is frequently needed in small quantities, the EIL Plus mini instant water heaters are the ideal choice.

• Hydraulically controlled mini instant water heaters with flow regulator and automatic supply control. 
• Almost constant temperature up to maximum performance. 
• Hydraulically controlled single-phase instant water heaters, dependent on the flow rate.
• The exact temperature is achieved by mixing cold water at the tap. 
• They include a special aerator for perfect water flow and further savings through the integrated flow regulator for installation in existing taps (thread M22/24).

Mini instant water heaters heat water directly at the point of use only when needed. High energy efficiency is ensured as there are no energy and water losses due to long pipe runs.

The PROFI-RAPID installation system guarantees easy and quick installation. Under-counter installation. Easy wall mounting: With 2-point safety. The rear panel also serves as a guide for wall drilling. The device cover and interior can be removed with a single motion. Quick water connection: External metal water connections with a diameter of 3/8" for immediate tap connection. Easy electrical connection: Comes with a ready-made power cable.

The Eil 6 Plus requires a permanent connection.

Resistance system (Bare Wire) that requires no maintenance, suitable for hard and soft water. Safety system with high-pressure switch. Overheating protection.

• Hot water available instantly
• Increase in water temperature by approximately 25°C
• Energy-efficient operation and water saving
• Can operate with pressure taps or free-flowing taps

The instant water heater is a type of water heater that heats water in real-time. It heats only the water that passes through it at that moment. There is no hot water storage tank. This has many advantages, such as energy savings, since only the water that is used is heated, and longer lifespan, as there is no water tank and no accumulation of salts in the resistance and other components.

It operates with electricity and is single-phase.

The instant water heater has an inlet pipe for cold water, which passes through the heating element, gets heated, and exits through the hot water outlet pipe. A necessary condition for the instant water heater to initially operate is the pressure of the incoming cold water should not be too low.

The water temperature is regulated by a thermostat, so it does not exceed a maximum value. The temperatures that the hot water reaches are preset so that one can use the hot water directly, without the need to mix it with cold water.

The maximum temperature that can be reached for hot water production is 50 °C, while the maximum water flow rate reaches up to 3.2 liters per minute. Indicatively, 38-42 °C degrees are standard for shower use.

• It is small in size and does not take up much space.
• There are no energy losses, as only the water that is used at that moment is heated. Therefore, we save on the electricity bill. In the classic water heater, the hot water that is not used goes to waste.
• The hot water used in the instant water heater is used as is, without mixing with cold, as happens in the classic water heater. Thus, we also save water, in addition to electricity.
• We do not need to wait for the water to heat up. As soon as we turn on the tap, hot water runs in a few seconds. The classic water heater takes a few minutes, depending on its size.
• The hot water never runs out. As long as we have the tap open, we will have hot water.