Internal puller from Germany for particularly narrow ball bearings, rings, sleeves, and Simmering seals.

Working method:

• Insert the internal puller inside the bearing and screw in the threaded shaft.
• The sharp edges of the shell parts are pressed behind the component to be removed.
• Only then can the reinforcement support braces be placed.
• Align both legs parallel to the threaded shaft to create a rigid single unit.

Can be used either with a slide hammer or with the reinforcement support braces.

Capacity: 19-25mm, Screw: M10, For bridge: 1.36/1, For slide hammer: 1.35/2.