Set the delivery location to see products according to your choice.
AustriaEnglish
BelgiumEnglish
BulgariaБългарски
CroatiaEnglish
CyprusΕλληνικά
CzechiaEnglish
EstoniaEnglish
FinlandEnglish
FranceEnglish
GermanyDeutsch
GreeceΕλληνικά
HungaryEnglish
IrelandEnglish
ItalyEnglish
LatviaEnglish
LithuaniaEnglish
LuxembourgEnglish
MaltaEnglish
NetherlandsEnglish
PolandEnglish
PortugalEnglish
RomaniaRomână
SlovakiaEnglish
SloveniaEnglish
SpainEnglish
SwedenEnglish
© 20[0-9]{2} Skroutz SA All Rights and Lefts reserved. FAQ | Terms of use | Privacy Policy | Cookie Policy
Key features:
The Teka vent hood with a suction power of 555 m³/h, which can adequately cover areas up to 19m².
See full descriptionfrom Easlanidis
Selected Store
Stock 5+ pieces
Skroutz Buyers Protection & 2 years warranty
Prices are calculated for:Luxembourg, Other Payment Options
Elegant aesthetics with designs, colors, and dimensions that meet all your requirements
The vent hoods feature filters with 12 layers & the ability to absorb up to 98% of grease. The filters are easily removable and can be washed even in the dishwasher at a low temperature.
If your electricity bill is always sky-high, it's time to start reducing it with the PERFECT A4 chimney, which achieves the top Class A rating in all 4 performance categories (Energy, Maximum Fluid Dynamics, Lighting, Grease Retention).
The Teka vent hoods have the ability to extract air to the outside environment for enjoyable moments in the kitchen, without steam and odors.
The LED light bars have the ability to provide light over a larger area above the cooking zone. At the same time, they are more efficient and environmentally friendly.
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.
Extremely good and efficient. I was looking for the strongest extractor hood available of the same type, regardless of its cost. There is no other alternative option. At least in its technical specifications, it is the best of its kind.
However, keep the following in mind:
* For it to work properly, it needs a 120mm pipe up to 4 meters and up to 2 90-degree angles.
* All extractor hoods need a slightly open window (like open-type fireplaces) to draw air properly. Otherwise, they create negative pressure in the room, do not draw, and if the house has good aluminum and good airtightness, they struggle and may burn out - especially if they have a long pipe / many angles / small pipe diameter.
* The filters fit just fine as long as you understand where they need to catch. They don't go in as easily as in the 2002, but if someone takes the time to understand the logic, they will manage just fine.
* Be careful to install the 2 plastic flaps (dampers) correctly at the top where the pipe goes (the little ears they have must face upwards), otherwise, they will hit and make endless noise. It is mentioned in the instructions as well.
* Check the design before you buy it because if you compare it, for example, with the TEKA 2002, you will need to cut the cabinet since it is quite taller. See the attached photo I uploaded. It protrudes quite a bit above the cabinet. To replace the 2002, I had to cut the cabinet and the existing plastic ventilation pipes with a jigsaw. Fortunately, the mounting holes are in exactly the same spots, so no new ones were needed.
* As someone else wrote, you can feel its power from the negative pressure it creates when you try to open an interior door, pulling and sealing it.
* Fortunately, the switches are not touch-sensitive, because if they were, I would be sure they wouldn't work over time.
* Read the instructions. It has a nice feature that allows you to program it to run for as long as you want and then turn off by itself.
* When you finish the installation, remove all the plastic. There is protective adhesive everywhere. Its final appearance, as you see it from every side, should be silver/stainless steel. If you don't remove them, they won't come off later.
* The noise is relative to the resistance caused by the pipe you have installed. Due to a small pipe or many angles, it makes noise. The extractor hood is not to blame. To get an idea of the minimum noise it can have and its performance, run it a bit without it being installed. Just plug it into the socket (after removing the filters because inside it has screws / consumables / manuals that need to be removed the first time).
* The power connection is made with a simple power plug (unfortunately without grounding).
edit 1/2025: After 5 years, it still works excellently
The noise is so-so, but it's not really annoying. The fact that many people mention issues with the filters is true; you just bend the little blade, the light turns on even without the extractor hood working (just lower the switch to minimum). Good value for money product, with nice LED light. Supplementary evaluation after 3 years of purchase. With the extractor hood off, the light flickers, the fuse burned out, and the house filled with smoke, and we almost caught fire. Sometimes the switch for the dimmer would stick, and the light wouldn't turn off. Not only malfunctioning but also a dangerous product. We will talk to the company.
Flawless. I have been using it on the first step for all these years. (with a pipe f120, important, and three bends to the roof, 6 to 7 meters distance)
I bought it because I was looking for a hood that pulls the smells and is strong while you actually cook in the kitchen and it doesn't smell next door BUT I have a very big issue with the noise...
It bothers me immensely! It sounds like a train on the high settings, to not make noise it has to be on the lowest setting...
very powerful and quiet as it is much stronger than many others at full power it makes a little noise and that is reasonable but at the 3rd level its suction is much higher than the classic it needs 150 mm duct and the kitchen door should not be closed or you should have a window slightly open its suction is very strong
It does what it promises.
Good noise level on the first steps.
Attention: you must remove the protective stickers from all surfaces before the first use.
3 stars due to noise. It is noisy for everyone or maybe we have a problematic installation? Any suggestions are welcome. Otherwise, satisfied
Very good absorbency, not an annoying sound, disadvantage is that you have to open it to give light... I bought it Christmas of 2020 and it broke July 2024... It lasted only 3.5 years. The first TEKA I had bought lasted a full 20 years. It's a shame they made them so disposable now.
The blinds that open and close, do not put them from the beginning, they hit each other and make noise.. otherwise, they are noisy but they suck well
It pulls quite well
It makes a lot of noise even on the lowest setting
It becomes chaotic on full power
In my opinion, a disadvantage is that when it is closed, you don't have the option to have the light on.
The light automatically turns on when you pull it out and the extractor fan "pulls"
Light color is blue
I don't think I would choose it again because of the noise it makes
Very good extractor. The only thing that bothers me is its white lighting. I would prefer warm lighting.
It makes very little noise and eliminates all odors even at low operating levels. It is necessary for a window to be open during its operation, otherwise it creates pressure in the room.
I have installed it in my mother's house for over 6 months. So far, it works perfectly without any issues.
Just after the warranty expired, the motor broke down, costing 230€. And a charge of 40€ from TEKA service to come and see it. Unacceptable, stay away..... Never again TEKA
It worked satisfactorily for about a year. Then it only worked on high scale and would turn off by itself after about 20 minutes, and it hardly picks up anything. Overall, it's a waste.
Very good....easy installation, but before you put the pipe, remove the 2 valves it has at the outlet for garbage, etc. at high speeds they will hit each other. It has excellent performance even at low speeds. Probably because it takes a 15mm pipe instead of the classic 12mm. The light is also quite good. It does not retain the setting you put when you close it and if you leave it open for a long time, the light turns off. I suppose it's to save electricity. As for the noise....it's an extractor fan, guys. It will make noise! This particular model pulls 550 cubic meters per hour, this cannot be achieved silently. Finally, it also has an adapter for a 12mm pipe, but I would not recommend it as it will cause "backflow" of air and in the long run it may burn the motor.
I have been using it for 3.5 years. Performance-wise, it is very good. However, I already hear the motor making excessive noise. It will burn out soon. So, it is not reliable.
Hello,
I have bought two, one for the country house and one for my friend's house. As a hood, it has very good performance and nice lighting, but the build quality is excessively fake. In both, the sliding part feels like it's broken and sometimes the small filter comes off, resulting in the lid not closing. It would be better if they had made it a bit more expensive and had better build quality, rather than cheap and fake.
Without any particular use, the volume increase button has cracked while it is still under warranty, which supposedly does not cover this defect.
Complete disappointment.. from the first day it was leaking oil and the company told me it was normal because the hose is new, but besides that, two months after the warranty expired, the motor got damaged and I am still waiting after 8 months for them to give me an answer if they will give me a discount for the replacement (because it cannot be repaired..) it's a shame because with such customer service, I don't think I will ever buy anything from this company again.
Just after the 2-year warranty ended, the motor broke down. The technician asked for 220€ and I decided to replace the extractor fan. Unacceptable, especially considering it's a TEKA product that I bought for its reputation and quality
It sucks everything! It has a one-meter long hose with a 12-inch angle. The two clicks you hear when closing it are the valves that prevent air from returning. The light turns on by itself (you need to close the default starting extractor when pulling the folding section, which should be left extended to keep the light on). So far, I haven't set it above 3. I struggled a bit with removing the protective membranes - you need to be careful not to leave any pieces behind.
2023-09-29: 3 months now, I haven't needed to set it above 3 - it absorbs everything!
I have had it for 4 years and without much use and the motor, even though I bought it for 150 on sale, its service life was 200. They told me it was a random event... Probably that's why it was on sale, to die in 4 years! Unacceptable.
The motor burned out (as the service said) in 2 years and 4 months. The cost of the motor is 180 euros so you have to buy another one. So, good for 2 years!
The best for the money... Truly awesome!!! I had a famous brand extractor at twice the price (440 euros) and this one is not only better in performance but in everything... I have had it for a year now, value for money‼️
I have it for 1 year and something.
5 stars from me because it does what it promises.
Yes, it makes noise even on the low setting, but it also has high absorption power.
I installed a 120mm pipe. I believe it would have been quieter with a 150mm pipe.
The filters, in my opinion, are a bit flimsy. The metal pieces need a little bending or a bit of patience when installing them.
The light it has is cool white and from what I saw, it is an LED strip. So it will be a bit inconvenient when it burns out (compared to having a regular screw-in light)
I have had it for quite some time and I have also faced the problem with the filter. Of course, I pulled the tabs back and the situation was somehow saved. It does its job for sure, but if it breaks, I wouldn't buy it again!
A few days ago I installed it. Very good purchase. However, I have some observations compared to the comments and reviews I had read before buying it:
1. The instructions (manual) are very bad.
2. It has really great power and indeed creates pressure in the room. It is good to leave a window slightly open when it is operating.
3. Very good lighting.
4. It comes with a bipolar plug from the factory. If you cut it, you will likely lose the warranty. Also, it seems unacceptable for it not to have a three-pole (Schuko) plug, meaning that its chassis is not grounded. Unacceptable for a product sold within the EU, and I don't know if there is a safety issue. Out of the 220 euros I paid, was it such a big cost for a third cable?
5. During installation, take into account the screws at the back that make it protrude 2-3 millimeters. It made it very difficult for me because it was sticking out more. It also prevented the main support screws from screwing in relation to the pattern, and even the cabinet from closing.
6. It has the adapter F150/125 inside it. I discovered it after I had already screwed it and ordered that specific reducer. It is very wrong that it is not described in the instructions that it exists and where it is. For those who haven't found it, simply open the large filter now and it will fall into your hands.
7. The small filter that I read about in a third of the comments, that it falls into the large filter, does not happen. Come on, really! If it happens to you, just open the ears of it a little!
8. The operating speed is the same as the one you had set. If it resets to the first speed, you have done something wrong. Maybe you should try changing the polarity in the power supply.
9. Don't forget to remove the protective film from the back before installing it. Also, you will have difficulty removing the rest of the protective films correctly
Very powerful machine and very good lighting.
After 15 days of use, the light does not turn on. The switch probably has a problem. It needs to be removed and taken for service for 15+ days. And all this after 15 days of use.
Efficient! No comparison to the previous Teka drawer we had! Choose it with your eyes closed!
The old one was from the same company so the installation was convenient for me. They have kept the same points on the screws as the old models.
The performance is very good. It is noisy on the high settings but it is understandable. The lighting is satisfactory.
The build quality is not very good. The mechanisms that hold the filters in the drawer are poor. I removed the drawer and reconstructed the notches that held them. I also tightened some terminals on the electrical part. Overall, I don't think it will withstand the test of time.
I have had it for a month and personally I have not seen better performance in a range hood! The durability over time remains to be seen, but for now, it's simply 5 stars!
Deals
Technology
Home & Garden
Fashion
Sports & Outdoors
Health - Beauty
Baby & Kid
Auto - Moto
Business - B2B
Books