1. MIXING:
A. The shades NATURAL, BEIGE - NTORE, COPPER - ACACIA - RED, BROWN - CHOCOLATE, INTENSE RED are mixed in a ratio of 1+1. I.E. 50 ml Beauty color + 50ml Oxycreme emulsion
B. SUPER BLONDS: The super blonds shades are mixed in a ratio of 1+2. For example, 50ml Beauty color super blond + 100 ml Oxycreme emulsion. In light bases or when maximum lightening is not desired, it is recommended to use 30V (9%) oxidizing cream. Also, for very fine or damaged hair, use 30V (9%) oxidizing cream.
C. DYE ON WHITE HAIR: Beauty color covers 100% of white hair. When white hair is more than 40%, the addition of a natural shade (2-10) is required as follows: i) from 40-60%, white hair: mix the desired color with a natural shade in a ratio of: 2 parts Beauty color shade of choice + 1 part natural shade. For example, Beauty color 50ml Nr. 6.60 + 25ml Nr. 6 (natural shade).
2. APPLICATION: Use the dye mixture immediately after mixing.
Protect the eyes. Protect your clothing. Use only the recommended ratios. During the application time, the mixture inside the shaker or bowl changes color. Do not worry. There is no consequence to the dye result.
2.1. TOTAL APPLICATION: In the same or darker shade: Apply the dye mixture evenly from the root to the tip, dividing the hair into sections. Waiting time: 30-40 minutes.
2.2 TOTAL APPLICATION: In a lighter shade or lightening: Step 1: Start about 2 tones away from the root and apply the dye to the lengths and ends of the hair. Waiting time for all shades: 20 minutes. For Super Blonds & Supreme Reds: 30 minutes. Step 2: Immediately after, apply the dye to the roots. Additional waiting time: For all shades: 30-40 minutes. For Super Blonds & Supreme Reds: 50 minutes. To make the color brighter, use Oxycreme with higher degrees on the lengths and ends than on the roots.
2.3. ROOT APPLICATION: Apply the dye mixture to the roots. Start from the areas where there is more white hair. For better coverage, apply enough product to the roots. Waiting time: 30-40 minutes. The crown because it has sensitive hair (fine roots) should be done at the end. If it is a lightening dye, start where more lightening is needed. In the case of lightening, you should apply a larger quantity than in the rest of the dyeing. Waiting time for Super Blonds: 50 minutes.
2.4. Uniform color from roots to ends of the hair:
a) If the color on the lengths and ends shows slight fading, spray the hair with a little water and apply the remaining mixture to the lengths and ends 5 minutes before the end of the waiting time.
b) If the color of the hair on the lengths and ends shows moderate fading, apply the remaining mixture after 20 minutes of waiting time and leave for 10-20 minutes.
c) If the color of the hair on the lengths and ends shows moderate fading, apply to the roots and then immediately to the lengths and ends. Waiting time see root application.
d) If the ends of the hair are very damaged and tend to "reject" the color, apply the desired shade to the roots and then add 5ml of lukewarm water and 2.5gr of a warm shade (.3,.4,.5,.6) to the mixture at the same tone height or one tone darker.
Apply the mixture to the lengths and ends. Massage well. Waiting time: 30-40 minutes.
2.5. APPLICATION FOR BASES-MIXTONES These are the shades that help us enhance the color of the dye, neutralize or correct unwanted shades, or correct any mistakes. The mixing ratio depends on the tone level of the base color. The lighter the base color, the less amount of mixtones bases we use. Starting from dark shades (in tone 2), we use approximately 9gr of MIXTONES for every 50gr of dye. As the shades lighten, the quantity is reduced by 1/2 to 1gr per shade, depending on the desired result.
3. RINSING & Aftercare: After the waiting time is complete, wear disposable gloves, emulsify well with warm water, and rinse the hair thoroughly until the water runs clear. Then, for neutralization and color stabilization, shampoo with a special shampoo and use a neutralizing milk for care with green tea extract and silk proteins.